No products in the cart.
MyoWare Muscle Sensor Development Kit
This MyoWare Muscle Sensor Development Kit contains most of the basic components to get you started with “muscle sensing”, the MyoWare board is an electromyography (EMG) sensor that outputs a signal relative to the muscle activity by measuring filtered and rectified electrical activity of a muscle.
Included in this kit are associated shields such as (Power, Cable, LED, and Proto), biomedical sensor pads and cable, as well as headers that can be soldered onto each shield, just make sure to take a look at our MyoWare Muscle Sensor Kit Guide below for tips, tricks and best practices for assembling your MyoWare boards..
Note: Both Power Shield and the LED Shield provide power, but at slightly different voltages. Don’t use both of these shields at the same time.
- 1x MyoWare Muscle Sensor
- 1x MyoWare Power Shield
- 1x MyoWare Cable Shield
- 1x MyoWare LED Shield
- 1x MyoWare Proto Shield
- 1x Sensor Cable – 3 Connector
- 10x Biomedical Sensor Pad
- 11x Stackable Header – 3 Pin, Female
- 3x Header – 3 Pin, Male