BIGTREETECH TMC2208 TMC2209 UART Stepper Motor Driver for 3D Printer

TMC2208

Features:

-It can effectively avoid problem such as running deviation losing step and fault caused by the overlade of the chip

-Avoid losing step and Jittering, Spread Cycle: The motor controlled by the PWM chopper mode operated more smoothly and without Jitter

-Large heat dissipation area, good heat dissipation effect

-Ultra-quiet, Stealth Chop can driver the motor to work under extreme silence

-Immersion Gold process, the better antioxidant

Specification:

Configuration: STEP / DIR or UART

Micro-steps: Up to 1/256

Micro-Plyer: 1/256

Logic voltage: 3.3V / 5V

Input voltage range: 4.75 - 36V

Motor Phase Current: 1.2A RMS, 2.0A Peak

Single Wire UART: For advanced configuration options

LOW RDSON: LS 280mΩ & HS 290mΩ (typ. at 25°C

TMC2209 V1.2

Description:

Blocking rotation detection.TMC2209 provides a load and loss of speed detection technology

2. Current dynamic adjustment. TMC2209 provides a current dynamic regulation technology that saves up to 75% of electrical energy.

For quiet operation and smooth motion.

Highly dynamic motor control chopper.

Current control for energy savings.

Sensor less motor load detection.

The hardware of the modes UART,DIR/STEP is the same. If you need to use UART mode, just need to modify the firmware.

Specification:

Micro-step :Up to 1/256

Micro layer: 1/256

Logical voltage :3.3V/5V

Input voltage range :4.75-36V

Package Include:

1xStepper Motor Driver